Delta Electronics VFD-E manual Revision June 2008, 04EE, SW--PW V1.11/CTL 139

		Chapter 4 Parameters
Settings	Function	Description
9	Desired Frequency	Active when the desired frequency (Pr.03.02) is attained.
	Attained
10	Terminal Count Value	Active when the counter reaches Terminal Count Value.
	Attained
11	Preliminary Count Value	Active when the counter reaches Preliminary Count Value.
	Attained
12	Over Voltage Stall	Active when the Over Voltage Stall function operating
	supervision
13	Over Current Stall	Active when the Over Current Stall function operating
	supervision
	Heat Sink Overheat	When heatsink overheats, it will signal to prevent OH turn
14		off the drive. When it is higher than 85oC (185oF), it will be
	Warning
		ON.
15	Over Voltage supervision	Active when the DC-BUS voltage exceeds level
16	PID supervision	Active when the PID function is operating
17	Forward command	Active when the direction command is FWD
18	Reverse command	Active when the direction command is REV
19	Zero Speed Output	Active unless there is an output frequency present at
	Signal	terminals U/T1, V/T2, and W/T3.
	Communication Warning
20	(FbE,Cexx, AoL2, AUE,	Active when there is a Communication Warning
	SAvE)
21	Brake Control (Desired	Active when output frequency ≥Pr.03.14. Deactivated when
	Frequency Attained)	output frequency ≤Pr.03.15 after STOP command.

11.06Multi-function Input Terminal (MI7)

11.07Multi-function Input Terminal (MI8)

11.08Multi-function Input Terminal (MI9)

11.09Multi-function Input Terminal (MI10)

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-139