Delta Electronics VFD-E 07.13, 07.18, 07.19, 07.20, 07.21, 07.22, 07.23, 07.24, 07.25, 07.26

Chapter 4 Parameters

If temperature exceeds the motor PTC overheat warning level (Pr.07.15), the drive will act

according to Pr.07.17 and display . If the temperature decreases below the result (Pr.07.15 minus Pr.07.16), the warning display will disappear.

07.13	Input Debouncing Time of the PTC Protection		Unit: 2
	Settings	0~9999 (is 0-19998ms)	Factory Setting: 100

This parameter is to delay the signals on PTC analog input terminals. 1 unit is 2 msec, 2 units

are 4 msec, etc.
07.18	Motor Rated Current (Motor 1)		Unit: 1
	Settings	30% FLA to 120% FLA	Factory Setting: FLA
07.19	Motor No-load Current (Motor 1)		Unit: 1
	Settings	0% FLA to 90% FLA	Factory Setting: 0.4*FLA
07.20	Torque Compensation (Motor 1)		Unit: 0.1
	Settings	0.0 to 10.0	Factory Setting: 0.0
07.21	Slip Compensation (Used without PG) (Motor 1)		Unit: 0.01
	Settings	0.00 to 10.00	Factory Setting: 0.00
07.22	Motor Line-to-line Resistance R1 (Motor 1)		Unit: 1
	Settings	0 to 65535 mΩ	Factory Setting: 0
07.23	Motor Rated Slip (Motor 1)		Unit: 0.01
	Settings	0.00 to 20.00Hz	Factory Setting: 3.00
07.24	Motor Pole Number (Motor 1)		Unit: 1
	Settings	2 to 10	Factory Setting: 4
07.25	Motor Rated Current (Motor 2)		Unit: 1
	Settings	30% FLA to 120% FLA	Factory Setting: FLA
07.26	Motor No-load Current (Motor 2)		Unit: 1
	Settings	0% FLA to 90% FLA	Factory Setting: 0.4*FLA
07.27	Torque Compensation (Motor 2)		Unit: 0.1
	Settings	0.0 to 10.0	Factory Setting: 0.0
07.28	Slip Compensation (Used without PG) (Motor 2)		Unit: 0.01
	Settings	0.00 to 10.00	Factory Setting: 0.00
07.29	Motor Line-to-line Resistance R1 (Motor 2)		Unit: 1
	Settings	0 to 65535 mΩ	Factory Setting: 0
07.30	Motor Rated Slip (Motor 2)		Unit: 0.01
	Settings	0.00 to 20.00Hz	Factory Setting: 3.00

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-101