Delta Electronics VFD-E manual Operation mode indication

		Chapter 4 Parameters
Parameter	Explanation	Settings	Factory	Customer
			Setting
	The Selections for	0: Save Keypad & Communication
		Frequency
	Saving Keypad or	1: Save Keypad Frequency only	0
02.13	Communication
	Frequency
	Command	2: Save Communication Frequency only
	Initial Frequency	0: by Current Freq Command
02.14	Selection (for	1: by Zero Freq Command	0
	keypad &
	RS485/USB)	2: by Frequency Display at Stop
02.15	Initial Frequency	0.00 ~ 600.0Hz	60.00
	Setpoint (for keypad
	& RS485/USB)
		Read Only
	Display the Master	Bit0=1: by First Freq Source (Pr.02.00)
02.16		Bit1=1: by Second Freq Source (Pr.02.09)	##
	Freq Command
		Bit2=1: by Multi-input function
	Source
		Bit3=1: by PLC Freq command (NOT for
		VFD*E*C models)
		Read Only
		Bit0=1: by Digital Keypad
	Display the	Bit1=1: by RS485 communication
02.17	Operation	Bit2=1: by External Terminal 2/3 wire mode	##
	Command Source	Bit3=1: by Multi-input function
		Bit4=1: by PLC Operation Command (NOT
		for VFD*E*C models)
Group 3 Output Function Parameters
Parameter	Explanation	Settings	Factory	Customer
			Setting
		0: No function	8
03.00	Multi-function	1: AC drive operational
	Output Relay (RA1,	2: Master frequency attained
	RB1, RC1)
		3: Zero speed
		4: Over torque detection	1
03.01	Multi-function	5: Base-Block (B.B.) indication
	Output Terminal	6: Low-voltage indication
	MO1
		7: Operation mode indication

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-9