Delta Electronics VFD-E manual Afm

Chapter 4 Parameters

Parameter	Explanation	Settings	Factory	Customer
			Setting
		8: Fault indication
		9: Desired frequency 1 attained
		10: Terminal count value attained
		11: Preliminary count value attained
		12: Over Voltage Stall supervision
		13: Over Current Stall supervision
		14: Heat sink overheat warning
		15: Over Voltage supervision
		16: PID supervision
		17: Forward command
		18: Reverse command
		19: Zero speed output signal
		20: Warning(FbE,Cexx, AoL2, AUE, SAvE)
		21: Brake control (Desired frequency
		attained)
		22: Drive ready
		23: Desired frequency 2 attained
03.02	Desired Frequency	0.00 to 600.0Hz	0.00
	1 Attained
03.03	Analog Output	0: Analog frequency meter	0
	Signal Selection	1: Analog current meter
	(AFM)
03.04	Analog Output Gain	1 to 200%	100
03.05	Terminal Count	0 to 9999	0
	Value
03.06	Preliminary Count	0 to 9999	0
	Value
	EF Active When	0: Terminal count value attained, no EF
		display	0
03.07	Terminal Count
	Value Attained	1: Terminal count value attained, EF active
03.08	Fan Control	0: Fan always ON	0
		1: 1 minute after AC motor drive stops, fan
		will be OFF
		2: Fan ON when AC motor drive runs, fan
		OFF when AC motor drive stops

4-10 Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11