Delta Electronics VFD-E manual 10.10, 10.11, 10.12, 10.13, 10.14, 10.15, 10.16

Chapter 4 Parameters

This function is only for ACI signal.

AC motor drive action when the feedback signals (analog PID feedback) are abnormal according to Pr.10.16.

10.10	Gain Over the PID Detection Value		Unit: 0.1
	Settings	0.0 to 10.0	Factory Setting: 1.0

This function is only for ACI signal.

This is the gain adjustment over the feedback detection value. Refer to PID control block diagram in Pr.10.06 for detail.

10.11	Source of PID Set point		Unit: 0.01
	Settings	0.00 to 600.0Hz	Factory Setting: 0.00
This parameter is used in conjunction with Pr.10.00 set 4 to input a set point in Hz.
10.12	PID Offset Level		Unit: 0.1
	Settings	1.0 to 50.0%	Factory Setting: 10.0
10.13	Detection Time of PID Offset		Unit: 0.1
	Settings	0.1 to 300.0 sec	Factory Setting: 5.0

This parameter is used to set detection of the offset between set point and feedback. When the offset is higher than the setting of Pr.10.12 for a time exceeding the setting of Pr.10.13, the AC motor drive will output a signal when Pr.03.00 ~ Pr.03.01 is set to 16.

10.14	Sleep/Wake Up Detection Time		Unit: 0.1
	Settings	0.0 to 6550 sec	Factory Setting: 0.0
10.15	Sleep Frequency		Unit: 0.01
	Settings	0.00 to 600.0 Hz	Factory Setting: 0.00
10.16	Wakeup Frequency		Unit: 0.01
	Settings	0.00 to 600.0 Hz	Factory Setting: 0.00

When the actual output frequency ≤ Pr.10.15 and the time exceeds the setting of Pr.10.14, the AC motor drive will be in sleep mode.

When the actual frequency command > Pr.10.16 and the time exceeds the setting of Pr.10.14, the AC motor drive will restart.

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-135