Delta Electronics VFD-E manual 03.04

Frequency						Chapter 4 Parameters
									detection
master
frequency				2Hz			4Hz range
	detection range								detection
desired								-2Hz range
frequency	waiting time								DC braking tim
03.02/03.14	for
	frequency								during stop
run/stop				ON			OFF			Time
setting 2
			OFF					OFF
master freq. attained					ON
(output signal)
setting 9/23		OFF			ON			OFF
desired freq. attained
setting 03 zero speed indication		ON			OFF				ON
setting 19 zero speed indication		ON			OFF				ON

output timing chart of multiple function terminals when setting to frequency attained or zero speed indication

03.03Analog Output Signal (AFM)

		Factory Setting: 0
Settings	0	Analog Frequency Meter (0 to Maximum Output Frequency)

1Analog Current Meter (0 to 250% of rated AC motor drive current) This parameter sets the function of the AFM output 0~+10VDC (ACM is common).

03.04	Analog Output Gain		Unit: 1
	Settings	1 to 200%	Factory Setting: 100

This parameter sets the voltage range of the analog output signal AFM.

When Pr.03.03 is set to 0, the analog output voltage is directly proportional to the output frequency of the AC motor drive. With Pr.03.04 set to 100%, the Maximum Output Frequency (Pr.01.00) of the AC motor drive corresponds to +10VDC on the AFM output.

Similarly, if Pr.03.03 is set to 1, the analog output voltage is directly proportional to the output current of the AC drive. With Pr.03.04 set to 100%, then 2.5 times the rated current corresponds to +10VDC on the AFM output.

NOTE

Any type of voltmeter can be used. If the meter reads full scale at a voltage less than 10V, Pr.

03.04should be set using the following formula: Pr. 03.04 = ((meter full scale voltage)/10) x 100%

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-63