Delta Electronics VFD-E manual Parameter Explanation Settings Factory Customer

Chapter 4 Parameters

Parameter	Explanation	Settings	Factory	Customer
			Setting
04.00	Keypad	0.0 to 100.0 %	0.0
	Potentiometer Bias
04.01	Keypad	0: Positive bias	00
	Potentiometer Bias	1: Negative bias
	Polarity
04.02	Keypad	0.1 to 200.0 %	100.0
	Potentiometer Gain
	Keypad	0: No negative bias command
	Potentiometer
04.03			0
	Negative Bias,
	Reverse Motion	1: Negative bias: REV motion enabled
	Enable/Disable
04.04	2-wire/3-wire	0: 2-wire: FWD/STOP, REV/STOP
	Operation Control	1: 2-wire: FWD/REV, RUN/STOP	0
	Modes
		2: 3-wire operation
04.05	Multi-function Input	0: No function	1
	Terminal (MI3)	1: Multi-Step speed command 1
		2: Multi-Step speed command 2
04.06	Multi-function Input	3: Multi-Step speed command 3	2
	Terminal (MI4)	4: Multi-Step speed command 4
		5: External reset
04.07	Multi-function Input	6: Accel/Decel inhibit	3
	Terminal (MI5)	7: Accel/Decel time selection command
		8: Jog Operation
04.08	Multi-function Input	9: External base block	4
	Terminal (MI6)	10: Up: Increment master frequency
		11: Down: Decrement master frequency
		12: Counter Trigger Signal
		13: Counter reset
		14: E.F. External Fault Input
		15: PID function disabled
		16: Output shutoff stop

4-12 Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11