Delta Electronics VFD-E manual Trial Run, Frequency Source, Method Source, MI1-DCM, MI2-DCM

				Chapter 3 Keypad and Start Up
Operation	Frequency Source				Operation Command
Method					Source
Operate from the	When setting communication by the PC, it needs to use VFD-USB01 or
	IFD8500 converter to connect to the PC.
communication
	Refer to the communication address 2000H and 2101H setting for details.
			FWD/Stop		+24V
	Factory setting:				MI1
			REV/Stop
					MI2
	NPN Mode
	NPN	Factory	Multi-step 1		MI3
	Sw1	setting	Multi-step 2		MI4
	PNP		Multi-step 3
					MI5
			Multi-step 4
					MI6
			Digital Signal Common
					DCM
					E
		* Don't apply the mains voltage directly
		to above terminals.			+10V
Operate from
				3	Power supply
external signal	Factory setting:
					+10V 3mA
	ACI Mode		5K	2	AVI
	AVI
					Master Frequency
	Sw2			1
					0 to 10V 47K
	ACI				ACI
	ACI/AVI switch				4-20mA/0-10V
	When switching to AVI,				ACM
	it indicates AVI2		Analog Signal Common		E

	Figure 3-1
MI3-DCM (Set Pr.04.05=10)	External terminals input:
	MI1-DCM
MI4-DCM (Set Pr.04.06=11)
	MI2-DCM
Operate from the
optional keypad
(KPE-LE02)

3.3 Trial Run

The factory setting of the operation source is from the external terminal (Pr.02.01=2).

1.Both MI1-DCM and MI2-DCM need to connect a switch for switching FWD/STOP and REV/STOP.

2.Please connect a potentiometer among AVI, 10V and DCM or apply power 0-10Vdc to AVI-DCM (as shown in figure 3-1)

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 3-3