Delta Electronics VFD-E manual Revision June 2008, 04EE, SW--PW V1.11/CTL 155

		Chapter 4 Parameters
Parameter	Explanation	Settings	Factory	Customer
			Setting
		2: Multi-Step speed command 2
04.06	Multi-function Input	3: Multi-Step speed command 3	2
	Terminal (MI4)	4: Multi-Step speed command 4
		5: External reset
04.07	Multi-function Input	6: Accel/Decel inhibit	3
	Terminal (MI5)	7: Accel/Decel time selection command
		8: Jog Operation
04.08	Multi-function Input	9: External base block	23
	Terminal (MI6)	10: Up: Increment master frequency
		11: Down: Decrement master frequency
		12: Counter Trigger Signal
		13: Counter reset
		14: E.F. External Fault Input
		15: PID function disabled
		16: Output shutoff stop
		17: Parameter lock enable
		18: Operation command selection (external
		terminals)
		19: Operation command selection(keypad)
		20: Operation command selection
		(communication)
		21: FWD/REV command
		22: Source of second frequency command
		23: Quick Stop (Only for VFD*E*C models)
		24: Download/execute/monitor PLC Program
		(PLC2) (NOT for VFD*E*C models)
		25: Simple position function
		26: OOB (Out of Balance Detection)
		27: Motor selection (bit 0)
		28: Motor selection (bit 1)

04.24Reserved

Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11 4-155