Delta Electronics VFD-E manual Device Status, Rst, Tmr, T5 K1000

Appendix D How to Use PLC Function

Explanations:

When the RST command is driven, motion of its specific device is as follows:

		Device					Status
		Y, M		Coil and contact will be set to “OFF”.
				Present values of the timer or counter
		T, C		will be set to 0, and the coil and contact
				will be set to “OFF.”
		D		The content value will be set to 0.
Program Example:
Ladder diagram:						Command code:		Operation:
	X0
			RST		Y5	LD	X0	Load contact A of X0
						RST	Y5	Clear contact Y5

Mnemonic

TMR

T-K

Operand

T-D

Function

16-bit timer

T0~T15, K0~K32,767

T0~T15, D0~D29

Explanations:

When TMR command is executed, the specific coil of timer is ON and timer will start to count. When the setting value of timer is attained (counting value >= setting value), the contact will be as following:

		NO(Normally Open) contact					Open collector
		NC(Normally Closed)			contact		Close collector
Program Example:
Ladder diagram:						Command code:		Operation:
	X0					LD	X0	Load contact A of X0 T5 timer
			TMR	T5	K1000
						TMR	T5 K1000	Setting is K1000

D-38 Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11