Note- If the C PU memory unit lower is inserted as far as it will go, it may not be possible to
liftthe lever. Lift the lever just be fore the CPU memory unit lower hits the rear and then
pushit fully h ome.
Note- Rein stall the PCIe card cassettes in their original positions by referring to the notes
thatyou m ade prior to the start of maintenance.
7.5.3 Installing the CPU memory unit lower
1. Install theCPU memory unit upper or a fi ller unit for a CPU memory unit
upper.
For details, see "7.5.2 Installingthe CPU memory unit upper."
2. Insert the CPU memory unit lower into the chassis while supporting i t from
belowwit h one hand.
3. Raisethe right and lef t levers of the CPU memory unit lower to secure it.
7.5.4 Restoring the chassis
1. Ifa crossbar unit was mounted, install the mounting frame and then tighten
thethree screws.
2. Ifany crossbar units were mounted, reinstall all of them.
For details, see "9.5 Installing a Crossbar Unit."
3. Installal l thePCIe card cassettes.
For details, see "13.6.2 Installing a PCI Express card cassette."
4. Connectall the cables for the external interface.
Thec ables to be connected are as follows.
■Interface cable connected to the PCIe card
■Crossbarcables (If equipment rack model 26xx or equipment rack model 16xx
isused, connect them in step 6.)
■XSCFBB control cable
■XSCFDUAL control cable
■XSCF-LANcable
■Serialc able
■LANc able
■SASca ble
■USBcable
FujitsuM10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･December 2013146