Note- For a b uilding block configuration, switch the mode switches of the master chassis
andthose chassis whose XSCFs are in the standby state.
XSCF> poweroff -a
PPAR-IDs to power off:00,01
Continue? [y|n] :y
00 : Powering off
01 : Powering off
Note- For a build ing block configuration, check the POWER LEDs on all the chassis that
makeup the system.
Note- For a b uilding block configuration, switch the mode switches of the master chassis
andthose chassis whose XSCFs are in the standby state.
5.4.1 Stopping the system with the XSCF command
1. Switch the mode switch on the operation panel to Service mode.
For details, see "2.2.2 Controlfunction of the operation panel."
2. LogintotheXSCFshell.
3. Execute the poweroff command.
Inresponse to the confirmation message, enter "y".
Inthe following example, the status of PPAR-IDs 00 and 01 displays "Powering
off",w hich indicates that the power to the physical partitions is being turned off.
Thefoll owing processes are performed.
- Oracle Solaris is completely shut down.
- The system stops and enters the POWERON READY state (The XSCF is running).
For details, see "6.2.2 Stopping the whole system" in the Fujitsu M10/SPARC M10
SystemsSystem Operation and Administration Guide.
4. Check that the POWER LED on the operation panel is off.
5.4.2 Stopping the system from the operation panel
1. Switch the mode switch on the operation panel to Service mode.
For details, see "2.2.2 Controlfunction of the operation panel."
2. Pressthe power switch on the operation panel for 4 seconds or more.
For details, see "2.2.2 Controlfunction of the operation panel."
Chapter5 Understanding the Preparations for Enabling Maintenance 63