Fujitsu M10-4, M10-4S - page 464

Front
connector on the operation panel.
Performthis step only when removing the cable (SIG).
Toremove the cable (PWR), proceed to step 10.
Figure28-19 Operation panel cable
10. Removethe cable from the terminal board.
■Forthe cable (PWR), push the connector toward the back while pushing up
thelo wer latch (A in the figure) with a flathead screwdriver. Confirm that the
lower latch (A in thefig ure) has been pushed to the back of the terminal
board.Push the connector toward the back while pushing down the upper
latch (B in the figure) with a flathead screwdriver.
FujitsuM10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･December 2013440