A
Note- Place the re moved crossbar unit on a grounded antistatic ESD mat.
Note - When mountinga crossbar unit, check the connectors on both of the chassis
andcr ossbar unit beforehand to confirm that no pin is bent and all the pins are neatly
arranged in lines. If a crossbar unit is mounted with a bent pin in a connector, the
chassis or crossbar unit may be damaged. Also, carefully proceed with the work to
prevent any pin from being bent.
Figure9-3 Opening the eject levers
3. Support the crossbar unit from below with one hand and carefully remove it
fromthe mounting frame.
9.5 Installing a Crossbar Unit
Thissectio n describes the procedure for installing a crossbar unit.
FujitsuM10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･December 2013186