XSCF> showboards -a
PSB PPAR-ID(LSB) Assignment Pwr Conn Conf Test Fault
---- ------------ ----------- ---- ---- ---- ------- --------
00-000(00) AssignedyyyPassedNormal
01-000(01) AssignednnnPassedDegraded
02-000(02) AssignedyyyPassedNormal
03-000(03) AssignednnnPassedFaulted
XSCF> switchscf -t Standby
The XSCF unit switch between the Master and Standby states.
Continue? [y|n] :y
XSCF> showpparstatus -p 0
PPAR-ID PPAR Status
00 Running
5.3 Powering Off the Physical PartitionRequiring Maintenance
Thissectio n describes the procedure for powering off the physical partition requiring
maintenance.This is applicable if the system has a building block configuration and
has multiple physical partitions.
1. Logi n to the XSCF shell.
2. Whenthe chassis requiring maintenance is operating as the master chassis,
executethe switchscf command to switch the master XSCF to a standby
XSCF.
Inre sponse to the confirmation message, enter "y".
When the chassis requiring maintenance is a slave XSCF, proceed to step 4.
3. Logi n to the master XSCF again.
4. Executethe showpparstatus command to confirm the operating condition of
thephysical partition.
Inthe following example, [PPAR Status] of PPAR-ID 00 displays "Running",
whichi ndicates that the physical partition is operating.
5. Executethe showdomainstatus command to confirm the operating condition
ofthe logical domain.
Inthe fo llowing example, [Status] of the logical domain displays "Solaris
running",which indicates that Oracle Solaris is operating.
FujitsuM10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･December 201360