XSCF> diagxbu -y -b 00 -t 01
XSCF> showlogs error
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? false"
XSCF> setpparmode -p 0 -m guestboot=off
XSCF> setpparparam -p 0 -s bootscript "setenv auto-boot? true"
Theexa mple below specifies the following:
00:BB-ID ofthe chassist o start the diagnosis
01:BB-ID o ft he destination where the chassis to start the diagnosis is connected
(You can specify one or more of these.)
Tospecif y multiple connection destination BB-IDs, enter a command like
"diagxbu -y -b 00 -t 01 -t 02".
4. Executethe showlogs command to confirm that the system is operating
normally.
For details, see "3.3.5 Checking log information."
5. Executethe setpparparam command to deactivate the Autoboot function of
thecontrol domain.
Inthe following example, PPAR-ID 0 is set for Auto boot.
6. Executethe setpparmode command to deactivate the Autoboot function of
theg uest domain.
Inthe following example, PPAR-ID 0 is set for Auto boot.
7. Start thesystem.
For details, see "6.4.1 Starting the system with an XSCF command"or"6.4.2
Starting the system from the operation panel."
8. Theok prompt appears.
9. Enablethe RAID volume to check the status.
For details, see "14.2.11 Re-enabling a hardware RAID volume" in the Fujitsu
M10/SPARCM10 Systems System Operation and Administration Guide.
10. Execute the setpparparam command to activate the Autoboot function of the
controldomain.
Inthe following example, PPAR-ID 0 is set for Auto boot.
11. Switchthe mode switches of the master chassis and those chassis whose
XSCFsare in the standby state to Locked mode.
-Fora building block configuration (without crossbar box)
Chapter7 Maintainingthe CPU Memor y Units 151