Note- See the procedure for system-stopped maintenance for inactive/cold maintenance in a
single-chassisco nfiguration.
Caution - To completely shut down the system, all the power cords must be
removed. If the power cords are not removed, an electrical failure may occur.
Note- Use the DR of the system board on a physical partition for active/cold maintenance.
Forthe XCP an d Oracle VM Server for SPARC/SRU versions that correspond to the DR, see
thelatest Produc t Notes.
Note- Active/co ld maintenance can be performed only for a building block configuration.
XSCF> showlogs error

8.3.5 Precautions for removal

Notethe following points when removing memory:
■Observethe memory installation rules when you remove memory. For details, see
"8.2.1 Memorymounting rules."
8.4 Enabling the Removal of Memory
Thissection describes the preparations that must be completed prior to the removal
ofmemory. The preparation procedure differs depending on the maintenance type as
follows:
■Active/Cold maintenance
■Inactive/Cold maintenance
■System-stopped maintenance

8.4.1 Active/Cold maintenance

1. Open the rack door.
2. Logi n to the XSCF shell.
3. Executethe showlogs command to identify the component requiring
maintenance.
For details, see "3.3.5 Checking log information."
FujitsuM10-4/Fujitsu M10-4S/SPARC M10-4/SPARC M10-4S Service Manual ･December 2013170