Hitachi S-4800 manual Stage and image shift tools, Mouse control stage, Setup dialog window

2.3.7.3Stage and image shift tools

Controls shown below will be shown on the scanning image.

Type1 manual stage Type2 motorized stage

Fig 2-23 Mouse control (stage)

(1) Type1 manual stage

It is for image shift operation. Move the mouse pointer to a position to be moved and

press down left or right button. The pointer will be changed to mark. Move mouse to target position holding down the button and then release the button.

If the above target position is near the center of the image area, the mause trace line is changed and the target position is fixed to the center of image.

(2) Type2 motorized stage

All 5 axes are controlled with stage control tools. Refer to 3.5.7 for operation procedure.

2.3.8Setup dialog window

The Setup dialog window has four tabs. To open the dialog window, use the following operation.

(1)Click the Setup button on the Tool button area of the Operation panel.

(2)Select following commands from the Setup menu.

Setup – Column	: Opens Column tab
Setup – Condition Load	: Opens Op. Cond tab
Setup – Condition Save	: Opens Op. Cond tab
Setup – Image Display	: Opens Image tab
Setup – Photo Condition	: Opens Record tab
Setup – Data Display	: Opens Record tab

(3)Click the Setup button on the OPE CONDITION block of the Operation panel

(4)Click the Load/Save button on the OPE CONDITION block of the Operation panel

2 - 44