ND-20292
CHAPTER 3
APRIL,1990
MEMORY BLOCK 4Bl- COI-I INITIALIZED VALUES .:
;
1. Go off line.
2. Depress F4, then F7.
3. Depress Fll. (See Note 1).
4. Dial CCU module number (1 - 4) where CO1 port is c 0 1
I NI TI ALI ZEI
to be programmed. Example: Module 1.
MOD1 SLOT? CH*
5. Dial CCU slot number (1 - 8) where CO1 port is to _
C 0 I I NI TI ALI ZEl
be programmed. Example: Slot 2.
-MOD1 S L OT 2 CH?
6. Dial CO1 channel number (1 - 4) of CO1 port to be
COI I NI TI ALI ZEl
assigned. Example: Channel 1. (See Note 2).
MOD1 SLOT2 C H 1
7. Depress Ll to L12 to set the desired parameters of the CO1 port. Corresponding LED(s) turn on or off
accordingly.
8. Depress ENTER key. (See Note 4).
COI I NI TI ALI ZEl
MOD1 SLOT2 CH2
9. Repeat steps 7 and 8 for all additional CO1 ports as required or go to step 3 to select a particular CO1 port.
OPERATION - AND - DISPLAY
OF F - LINE (X-XX)
PROGRAM MODE
-C A R D MODE
,c 0 I I NI TI ALI ZEl
-M 0 D ? SLOT* CH*
10. Depress the SPKR key to go back on line.
300 - 198