,

1

4.1.2 The Genie Voice Mail System provides two ports (AIUs) for Voice Mail Access. These ports

connect to two (of the four available) VMI-E extension positions. These VMI-E extensions should

be cross-connected from the appropriate J block on the MDF and connected to an RI1 1C connector

to facilitate connection to the Genie using modular line cords (See Figure 11.

66BLOCK

GENIE

 

 

PORT

2

0

STATUS

MDF

TO GENIE MODULAR

PORT

1

.

STATUS

 

 

 

 

CONNECTORS

 

 

 

 

 

PORT 1 AND PORT 2

0 GIAGNOSTIC

 

HALT

 

\

Figure 1. Genie Connection Block Diagram

4.2Electra Mark11 System Programming

4.2.1If the VMI-E ETU is being added to an existing system in an interface slot previously occupied by

a different type of ETU, it is necessary to assign the interface slot to be used for the VMI-E ETU in

Memory Block 4Cl. (Refer to Chapter 3 of the Installation/Service Manual).

4.2.2The two voice mail extensions connected to the Genie System can be programmed in the Voice

Mail Hunt Group in Memory Block 2C4. (Refer to Chapter 3 of the Installation/Service Manual).

4.3 Installing/Initializing Genie

NOTE: Ensure both the Genie and the computer terminal power switches are turned off.

4.3.1Configure the serial computer terminal to be used with the Genie as follows: 8-bit word length

0 no parity (ignore parity on some terminals) o 1 stop bit

auto-line feed off full duplex

a 1200 baud

2of 3

Page 624
Image 624
NEC nd-20292 manual Mdf