NEC nd-20292 manual Fdd I/O

ND-20292

CHAPTER 7

APRIL. 1990

2.Insufficient Data

When this program is transferred from the LCR-E ETU to the computer and an LCR program was created (which does not produce enough information to allow Call Routing), a display, similar to the one to the right, is shown.

3.Electra Mark II Not Ready

If the computer is unable to communicate with the LCR-E ETU, a display similar to the one at the right is shown.

NOTE: During the input of data or commands, if an invalid input is keyed into the computer, it will generate a beep tone to indicate an invalid command or data was entered.

SAMPLE LCD INDICATIONS

ROUTE ADVANCE TABLE DOWN LOAD START ABNORMAL END

SYS DATA INCOMPLETE 4

AREA CODE TABLE DOWN LOAD START

‘ABNORMAL END
KEY SYS NOT READY	4

ERROR REASON POSSIBLE SOLUTION COMMAND MODE

Line Trouble

FDD I/O

Error

LCR-E ETU and computer Disk Drive not communicating properly

Computer and Disk Drive not communicating properly

Check RS-232C cable. Verify cable	Down Load
connections. Ensure LCR-E ETU	Up Load
Busyout switch is ON	Verify
	System Control
Check cable between computer and	All commands except
Disk Drive. Check power on Disk	System Control
Drive. Check for properly inserted
diskette. Check that diskette write
protect tab is set properly.

Printer Not Ready

LCR Restarted

System Data Incomplete

Key System Not Ready

Beep Tone

Computer cannot communicate with printer

LCR-E restart during command associated with LCR-E

Insufficient Data received from LCR-E

Invalid data or no data from LCR-E

Invalid input keyed in.

Check connections to printer. Check	Print Out
printer power. Check that printer is
ON LINE. Check paper feed.
Check baud rate on COM Port and	Down Load
LCR-E card. Replace LCR-E.	Up Load
	Verify
	System Control
Check LCR program. Down Load all	Down Load
Tables. Replace LCR-E
Check LCR-E switch settings. If	Down Load
settings are correct, replace LCR-E.
Check cursor position to determine	All command modes
required input and enter valid entry.

700 - 58