NEC nd-20292 manual JAN 01 MON

ND-20292

CHAPTER 9

APRIL, 1990

If no modems are used (direct connection).

Disulav shows:

	< MARK11 >
EXT LINE			< OFFHOOK >
1159	JAN 01 MON
LK	1	5	9
	____	____	____ ___	0
			l3

Alt H = Help Screen

. .

NOTE: The following display indications are provided on the computer when used for remote administration:

q- Line key in use - green - steady X - Line key flashing

* - Line key in use - red- steady

-- Line key is idle

12.Press #, *, 0 and c (RETURN) to go off-line (Program Mode). Program as you would with a ETE-16D-( 1. Pressing the Alt H shows the number of keystrokes needed for proper programming.

(Help Screen).

< MARK11 >

OFF-LINE <X.Xx > < OFF HOOK >

PROGRAM MODE

LK 1 5 9 13

____ ____ ____ __-_

Alt H = Help Esc = Modem Online

I

:\ >

13.To exit the RAA terminal emulator program, perform the following procedures:

1.Insure that the RAA is ON-HOOK.

2.Press ESC to display the modem screen (OK will appear on the screen within a few seconds).

3.Press ESC again. The following prompt will be displayed:

4.Enter Y (yes) if calling another modem.

:\> -

OR

Enter N (no) if not calling another modem.

a.If selection is Y, go back to step 3 and continue from there.

b.If selection is N, the following prompt will be displayed:

c.If selection is (ESC), the following prompt will be displayed.

:\ > Exiting RAA Emulator Press any key to exit _

If N was selected, press any key to terminate the modem connection. The computer boots MS-DOS@.

If (ESC) was selected, press any key to use DATASAVE program. The modem will not be disconnected.

NOTE 1: Anytime ? is Pressed on the PC, (while idle or in program mode), a SELF CHECK OK

!!!display is received. This verifies that the

modem and the RAA-E are communicating.

NOTE 2: Anytime ESC is Pressed on the Computer, (while idle or in program mode), a

CONNECT XXXX (BAUD RATE CHOSEN) c(RETURN) display is received. This verifies that the modem and/or PC and the W-E are communicating.

NOTE 3: After SELF CHECK is performed, press t(RETURN) to return to the programming screen. After you are in a memory block, and a self check is performed, whenever another function is attempted before *(RETURN) is pressed an ALARM 1 is received.

940.6	GENERAL PROGRAMMING NOTES
In the	above example, entering information to the	.‘.I
RAA-E Unit is done as follows: type Fl, press
*(RETURN) to enter information to the RAA-E unit;

900 - 14