NEC nd-20292 manual Phase Executing Normal END Abnormal END Line Trouble

ND-20292

CHAPTER 7

APRIL, 1990

NOTE 1: The displays shown are typical of what may be seen during the clearing process. The blocked off area is replaced with the name of the selected table name. Due to the large memory used in the office code table, when it is cleared the display will show darkened cursor blocks to indicate the progress of the clearing process.

NOTE 2: At the end of the clearing process, depress CR (RETURN) to get back to the System Data Clear Menu.

NOTE 3: Refer to the table of errors (elsewhere in this chapter) for further guidance if a problem is encountered.

8.System Control Mode

The LCR Main Menu provides an option to restart the LCR-E ETU. This option is made available to allow resetting the LCR-E ETU without affecting the rest of the system (in other words a CPU-EC 1 reset is not necessary to reset the LCR-E ETU). Under normal conditions this option is not used.

To use this option the following procedure is required.

With the LCR Main Menu in the display, enter 10, then depress RETURN. The display shown is provided.

If no problem is encountered during the restarting process, the display shown is provided.

If a problem is encountered during the restarting process, the display shown is provided.

NOTE 1: After the restarting process is completed, depress CR (RETURN) to get back to the LCR Main Menu.

SAMPLE LCD INDICATIONS

PHASE EXECUTING 0

PHASE EXECUTING

NORMAL END 4

PHASE EXECUTING

ABNORMAL END

LINE TROUBLE 4

700 - 56