NEC nd-20292 manual 2of6

4.4When called party answers, lift the handset and converse.

4.5After call is established, manually turn OFF the Autodialer by depressing it’s ON/OFF button.

5.PROCEDURE

5.1Turn the Multiline Terminal upside down (face down) and locate the access panel on the bottom of the

Multiline Terminal, refer to Figure 1.

5.2Disconnect the modular line cord from under the telephone and from the RI-1 lC/W jack.

5.3Disconnect the modular haz:dset cord from the lower housing.

5.4Slide the directory out of the way (Not required for ETE-6-1 Multiline Terminal)

5.5Removal of access panel (Perform only the step that applies, either 5.5.1 or 5.5.2) Refer to Figure 1.

5.5.1ETE-GD-1, ETE-IGD-1, or ETE-16K-1 Multiline Terminal; Insert flat screwdriver blade into

notched opening (shown as A) and apply light upward pressure until access panel is cleared of

the front lip, at the same time apply pressure (towards you) at the rear of the pedestal (shown as B) until the access panel moves towards you. Remove panel.

5.5.2ETE-6-1 Multiline Terminal; depress spring loaded notched tab (shown as C) on the access

panel and apply upward pressure. Remove panel.

NOTE: Do not discard removed access panel. While it will not be used at this time, save for possible future use.

5.6Locate the eight pin jack labeled “ADA”, as seen through the housing access opening of the -Multiline

Terminal housing.

5.7Unplug the four pin connector ended harness (labeled “HAND”) and extend it out from the housing

access opening, of the Multiline Terminal.

5.8Set the Dip switches on the ADA-E unit as shown on Table 1 (See Figure 3). Place the jumper strap

across ST2 and the center pin. Set SWI to the “BREAK” position.

5.9Remove approximately 3 inches of outer insulation from both ends of the 4 conductor station wire cable

and strip off + inch of wire insulation from each of the four wires; solder or crimp a spade lug to each wire end.

5.10.Make the RJ-35X connections as indicated in Figure 3 using the prepared 4 conductor station wire

cable. Use one of the two spade tipped jumper wires provided with the ADA kit to make a connection between Tl and T5; connect the other jumper wire between T2 and T4 on the ADA-E unit.

5.11Locate and insert the four pin connector ended harness from CNl on the ADA-E unit into the jack

labeled “HAND” in the Multiline Terminal.

5.12Locate and insert the eight pin connector ended harness from CNl and CN2 on the ADA-E unit into

the jack 1abeled”ADA” in the Multiline Terminal.

5.13Insert the four pin connector ended harness (removed in step 5.7) into the four pin jack, CK3, located on the ADA-E unit.

2of6