NEC nd-20292 manual Programming

6.PROGRAMMING

NOTE: The CONFER@ unit is programmed via the control line, which is the last CO line connected to the

66 block on the MDF. The following software commands (and their function) are dialed with the telephone keypad to program the CONFER@ unit:

1 Places current party on hold and provides dial tone to dial a new party into the conference.

2 Disconnects the last party called.

3 Establishes a conference of all parties on hold.

196 Allows entering remote access authorization code.

197 Removes the CONFER@ unit from remote access mode.

198 Activates remote access mode on the CONFER’3 unit.

199 Places the CONFER@.unit in conference mode so that a conference can be initiated internally.

#Terminates the conference.

6.1Remote Access and Authorization Code Programming:

From a Multiline Terminal within the Electra Mark11 system:

6.1.1Depress the line key with the control line appearance.

6.1.2Dial 196 and after receiving confirmation tone, dial a 4-digit authorization code.

6.1.3Dial 198, receive confirmation tone and then dial tone; hang up. (If no confirmation tone is

received, either the authorization code is not programmed or was lost due to a power interruption).

6.2Removing the CONFER@ Unit from Remote Access Mode:

From a Multiline Terminal within the Electra Mark11 system:

6.2.1Depress the line key with the control line appearance.

6.2.2Dial 197; hang up.

7.OPERATION

7.1Establishing an internally initiated conference:

7.1.1From a Multiline Terminal within the Electra _VarkII system, lift the handset and depress

the line key assigned as the control line for the CONFER9 unit.

7.1.2When CO dial tone is heard, dial 199 to initiate a conference call. Note that dial tone is

broken momentarily and new dial tone is received indicating that the CONFER unit is enabled.

7.1.3

Dial

the

telephone

number

of

the

first

party

to

be

conferenced.

When

the

first

party

answers,

inform

the

party

that

you

are

initiating

a

conference

call

and

then

dial 1.

Dialing t

puts

the

party

on hold and

new

dial

tone

is received.

(If

dialing

1 returns

busy

tone,

this

indicates

that

no more lines are available).

NOTE:

When

dialing

a

telephone

number,

do

not

wait

more

than

5

seconds

between

digits.

Also,

after

the

telephone

number

is

dialed, wait at least 5 seconds before depressing

command

digits

1, 2, or

3.

This

time

delay

is

required

by the

system

to

differentiate

between

the

called

telephone

number

and the command

digit.

7.1.4

Repeat

step

7.1.3

for

all

parties

to be

conferenced.

If

a

mistake

is

made

in

dialing,

or

if

the

number

dialed

is

busy,

dial

2

to

disconnect

the

last

number

called

(Wrong

number

or

busy

number).

2 of 5