ND-20292
CHAPTER3
APRIL, 1990
KEY FUNCTION (OFF LINE)
SPKR - ON/OFF Line
F/W - Skips to the next letter position
CLEAR - Clears current name assignment
ENTER - Enters each assignment
B/W - Moves back one letter position
GUIDE TO FEATURE PROGRAMMING
MEMORY BLOCK BEING MEMORY BLOCK THAT MEMORY BLOCK THAT MAY
PROGRAMMED MUST BE PROGRAMMED HAVE TO BE PROGRAMMED
3C2
CPU-EC4 or higher.
NOTES:
1. For CPU-EC3 (or lower revision levels) ETUs,
this memory block was used for Trunk Group
name assignments. Trunk Groups l-8 could be
assigned.
2. After a trunk has been selected, the display will
show any previous name assignment. (Default
name: CO CALL).
3. The name assigned to each trunk is limited to
eight (8) characters, including spaces. Each
character is entered by selecting a dial key and
depressing it a number of times. Use the table
below as a guide. The F/W and B/W keys are
used to move to the next or previous entry.
The dial pad key patterns repeat every six
depressions.
I I
4. Depressing the ENTER key automatically
advances the display to step 3.
r'-' _._.-._._._._.-.-.-.-.-.-.-.-.-.---.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.
1
i

GENERAL INFORMATION - TRUNK NAME ASSIGNMENT

i
i i
i i
i This area of the memory block is used to assign names (of up to eight (8) characters, including spaces) to each i
i trunk. These names will appear in the displays of Multiline Terminals so equipped, when receiving ring f
i transferred, DID, Tie line or DIT calls, to an idle extension. I
i. .__.___._._._.-.-.~.~.~.~.~.-.-.-.---.-.-.-.-.-.-.-.~.~.~.~.~.~.~.-.-.-.~.~.~,~.~.~.~.~.~.~.~.~.~.~.-.-.~.-.-. j
300-165