NEC nd-20292 manual DS-004

	ETI NUMBER:		DS-004
6.8	TA-20: For ETE-1-2Revision B and higher.	Connect the leads from		the TA-20 Handset Amplifier to the
	spade lug connectors on the ETE-1-2 PCB. Refer to Table- 3 and Figure 4. Needlenose pliers may be used to
	push spade lugs into the receptacles.
6.9	S-l 1: For ETE-l-2 Revision B and higher.	Connect	the leads from the S-l 1 Handset Amplifier to the spade
	lug connectors on the ETE-l-2 PCB. Refer to Table		- 4 and Figure 5.	Needlenose pliers may be used to push
	spade lugs into the receptacles.

6.10Following the pre-molded guides inside the access panel cover assembly, cut the notch and route.the TA-20 or S-l 1 cable through this notch. (See Figure 6.)

6.11Attach the access panel cover to the Dterm II main body.

6.12Use a piece of double sided tape to secure the TA-20 or S-l 1 Handset Amplifier to the side of the Dterm II telephone.

6.13Connect the line and handset cords to the Dterm II.

6.14Test for normal operation

NOTE:	If the TA-20 or S-l 1 is disconnected from the ETE-l-2 telephone, Strap 58 must be reconnected for proper
	operation of the telephone.

Table - 3 TA-20 Handset Amplifier Cable Connection (ETE-1-2 Rev. B or higher)

TA-20 HANDSET AMPLIFIER CABLES	DTERM SPADE LUG CONNECTORS
YELLOW	RX1
RED	RX2
GREEN	Jl
BLACK	J3

*Remove the existing spade lug connector from RX1 and plug it in Jl.

**Cut Strap 58 on the PCB.

Table - 4 S-l 1 Handset Amplifier Cable Connection (ETE-l-2 Rev. B or higher)

I	S-11	HANDSET AMPLIFIER CABLES	I	DTERM SPADE LUG CONNECTORS	I
		YELLOW		RX1
		RED		RX2
I ~~		GREEN	I	RX3	I
		BLACK	I	J3

*Remove the existing spade lug connector from RX1 and plug it in Jl.

**Cut Strap 58 on the PCB.

4OF6