NEC nd-20292 manual Consecutive dialing cannot be made in the following cases

NOTE: Consecutive dialing cannot be made in the following cases:

lStation or system speed dialing sequence follows a manual dialing sequence.

lStation or system speed dialing sequence follows another speed dialing sequence.

2.Answering:

lLift handset and converse.

3.Placing A Call On Hold:

With call in progress:

lDepress the FLASH key (or momentarily depress the hookswitch) and receive second dial tone.

lDial access code (Default: 4 #) to place call on exclusive hold and hang up.

lLift handset to place another call or to retrieve the held party by dialing access code (Default: 4 #).

4.Abandoning a Call a. Using the handset:

lRestore handset.

ND-20292

CHAPTERS

APRIL,1990

b.Using the FLASH key (or momentarily depressing the hookswitch):

l Depress the FLASH key and receive second dial tone.

lDial the CO release access code. CO/PBX/Tie line/DID call is released and new internal dial tone is provided.

OR

Dial the Hookflash to CO access code and new outside dial tone is received.

5.Sending a Hookflash to the CO/PBX Line: With call in progress:

lDepress the FLASH key (or momentarily depress the hookswitch) and receive second dial tone.

0	Dial the Hookflash		to CO access code.
NOTE:	CO Release	access code and Hookflash		to CO access code must
	be assigned	to the	system before these	features can be used.

This feature will operate only when the trunk is programmed as a PBX line.

400 - 143