ND-20292
CHAPTER 3
APRIL, 1990
MEMORY BLOCK 4B9 - VMI INITIALIZE 2 ASSIGNMENT : ‘~3
.,j
OPERATION -AND- DISPLAY
1. Go off line.
2. Depress F4, then F7.
CARD MODE
3. Depress F19.
OF F - LINE (X.Xx)
PROGRAM MODE
VMI lNlTlALlZE2
MOD? SLOT* CH*
4. Dial the module number to be assigned.
VMl lNlTlALlZE2
Example: Module 1.
MOD1 SLOT? CH*
5. Dial the slot number to be assigned.
Example: Slot 7.
VMl INITIALIZE2
MOD1 S L OT 7 CH?
6. Dial the channel number to be assigned.
VM I INITIAL IZE2
Example: Channel l.(See Note 1).
MOD 1 SLOT 7 C H 1
NOTE:
The following conditions apply when either the first or second VMI-E ETU is entered.
Channel 1 affects VMI-E Ports land5
Channel 2 affects VMI-E Ports 2and6
Channel 3 affects VMI-E Ports 3and7
Channel 4 affects VMI-E Ports 4and8
(CPU-EC4 or higher revision is required to support two VMI-E ETUs)
7. Depress Ll to L12 to set the desired timing parameters of the selected VMI port. (See Note 2).
8. Depress ENTER key. (See Note 3).
VMI INITIAL lZE2
MOD 1 SLOT7 C H 2
9. Repeat steps 7 and 8 for all VMI ports to be assigned.
10. Depress the SPKR key to go back on line. ..-:
;’
300 - 212