NEC nd-20292 manual Verify Mode

At this time selection of one of the available table numbers will result in the display shown:

•Example for area code up load: depress 1, then depress CR (RETURN).

NOTE 1: The display shown is an example of area code data being up loaded from the LCR-E ETU into the floppy disk. The name of the table selected will be shown in the display.

NOTE 2: Exceptions to Note i, are the office code table and all data up load selections. These are shown in the All Data Up Load Start display. These two selections, due to their large memory requirements, show darkened boxes to indicate the relative amount of data that has been transferred.

NOTE 3: During up load, (if no problems are encountered) the display shown at right, or one similar to it, is provided.

Depress the CR (RETURN) key to return to the Down Load Menu.

NOTE4 If a problem is encountered during up load, the following display (or one similar to it) is provided. Depression of the CR (RETURN) key is required to return to the Up Load Menu.

NOTE 5: It is recommended that the RS-232C cable between the LCR-E ETU and the computer be checked prior to doing a down load or up load.

3.Verify Mode

Selection of verify mode results in the menu display shown at right.

At this time selection of one of the available table numbers will result in the display shown at right:

Example for area code verify: Depress 1, then depress CR (RETURN).

ND-20292

CHAPTER 7

APRIL, 1990

SAMPLE LCD INDICATIONS

AREA CODE TABLE UP LOAD START

OFFICE CODE TABLE UP LOAD START rnH

ALL DATA UP LOAD START

I AREA CODE TABLE UP LOAD START

NORMAL END 4

II

ALL DATA UP LOAD START

ABNORMAL END(OFFICE CODE TABLE)

LINE TROUBLE 4

		***VERIFY***
1 AREA CODE TABLE			6 EXTRA CODE TABLE
2 WEEKLY		SCHEDULE	7 OFFICE CODE TABLE
3	DAILY SCHEDULE		8 HOME NPA CODE
4	ROUTE	ADVANCE	10 ALL DATA
5 ROUTE		TABLE

ENTER MENU NO. 0

AREA CODE TABLE VERIFY START

700 - 37