NEC nd-20292 manual Dss Key, Led Off

ND-20292

CHAPTER 2

APRIL, 1990

LED

DSS KEY

(see Note 1)

Table 200-14 DSS/BLF Visual Indications:

STATUS FLASH PATTERNS

Station is idle or in the busy

mode and its Primary

Extension has an incoming call, call on hold, or recalling call.

Station is off-hook on a call and its Primary Extension is idle or in the I-Use mode. **

Station is idle or in use and its Primary Extension is in use by another station * or off-line or station lockout.

Red

Green

Red (Flashing)

Do Not Disturb ReGinking)

[nternal and

&Fgal	In Use
Message	DSS/BLF	in Message Mode,
Waiting	Message	at station
Night	Night Mode
Transfer
	-	ON
		OFF

NOTE 1: Steadily	Lit	Red LED		-	Attendant
Flashing	Red		LED	-	Attendant
Winking	Red		LED	-	Attendant
Steadily	lit	Green LED		-	Attendant
LED OFF				-	Attendant

		Red
		Red
		Red
I	I	I
0 sic	1 set	2 set

cannot override a station in this condition cannot override a station in this condition can override a station in this condition can override a station in this condition can call a station in this condition

NOTE 2: LED indications on DSS keys are the same regardless of dual path, but what Attendant can do may be different.

NOTE 3: On the Multiline Terminals with built-in BLF, LED flash patterns are same as the ones on the DSS/BLF Console, but green is not available.

*= Phantom extensions appearing on the DSS/BLF also provide this indication when in use.

**= Virtual extensions appearing on the DSS/BLF also provide this indication when in use.

4.Cabling Requirements

For connecting of data terminal equipment to the DTA-E Unit, a locally provided RS-232C straight cable with a male connector at each end must be obtained.

Cable specification is as follows:

GND 2	Length:	50 feet (15m), maximum.
	Type:	Shielded RS-232C straight cable with at
Figure 200-6 DTA-E Unit Power Connector		least one RS-232C male connector.

200 - 14