NEC nd-20292 manual ETI Number, Procedure

ETI NUMBER: IX-003

6.PROCEDURE

6.1Disconnect the line and handset cord from the Dterm telephone.

6.2Place the Dterm II upside down on a clean, flat work surface.

6.3Slide the Directory out and place it aside.

6.4Remove the access panel by applying pressure (at the notch of the panel) and slide the accesspanel out as shown in figure 1.

t the Access Panel

Dterrn II Telephone

Figure 1. Access Panel Removal

6.5Cut strap 58 on the telephone PCB as shown in Figure 2. and Figure 3. (Strap 58 is visible from the access panel window.)

NOTE:

If the

revision

for

the

ETE-l-2

telephone

is A (e.g., 294 A) proceed

to step

6.6

If the

revision

for

the

ETE-l-2

telephone

is B or higher proceed

to

step

6.7

The revision

level of an ETE-l-2

telephone can be determined

from

the

label

on the bottom

housing

of the

telephone.

Example:

If the Lot

No. on

the label is 295A, the revision

level

of

that particular

telephone

is A.

6.6For ETE-1-2 Revision A. Connect the leads from the JS-180 to the spade lug connectors on the PCB. Refer to Table - 1 and Figure 2. Needlenose pliers may be used to push spade lugs into their receptacles.

6.7 For ETE-1-2 Revision B and higher.	Connect the leads from the	JS-180 to the spade	lug connectors on the
PCB. Refer to Table - 2 and Figure 3. Needlenose pliers may be		used to push spade	lugs into their
receptacles.

6.8Following the pre-molded guides inside the access panel cover assembly, cut the notch and route the Jackset JS-180 cable through this notch. (See Figure 4.)

6.9Insulate spare Jackset wires with electrical tape. Store these wires in a neat bundle in the access panel cover.

6.10Attach the access panel cover to the Dterm II main body.

6.11Connect the line and handset cords to the Dterm II.

6.12Test for normal operation.

2OF5