NEC nd-20292 manual FRI Hook

ND-20292

CHAPTER 9

APRIL, 1990

1983 / 01 / 01 00:00:02 (C)Microsoft #l

~~~~~~	TEXT	TELCOM	-.-
__	-.-	-.-	__
-.-	__	__	__
--	__	--	__
__	_-	-.-	-.-
--	__	-.-	-.-
Save	as _		-.-
3. Type:	ADMI.BA
Press: c (Return).
Display prompts: Ready?
Press: c	(Return)		‘7%

Red LED on disk drive flashes on, then off. Display changes to:

1983/01 /Ol 00:00:04 (C)Microsoft #l

~~~~~~~	TEXT	J-ELCOM		ADMI.BA
--	__	__		--.
__	__	__		--
__	__	-.-		__
	__			.
__		__		-.-
__	_ _	__		-.-
Load	Save	Name	List	21i.63

940.2.2RAA PROGRAM BOOT (PC-8300)

1.Using the cursor movement keys, move the cursor to the upper right hand corner of the display over the word ADMI.BA

2.Press: c (RETURN) Display prompts:

* * * MAINTENANCE TERMINAL * * *

HIT ANY KEY TO LOG IN

3.Press any key. (A tone is provided.)

Display prompts:

PLEASE SELECT YOUR SYSTEM

A:ELECTRA-IMS

B:ELECTRA-MARKII

4.Press B to select the Electra Mark11 System. (A tone is provided.)

Display prompts:

PLEASE INPUT KEY DATA FOR bps

A :	2400 bps	B :	1200 bps
C :	600 bps	D:	300bps

NOTE: Baud Rate selected must be the same as the setting of Baud Rate Switch on RAA-E Unit and at which modems are working (when provided).

5.Press appropriate key for Baud Rate. (A tone is provided.)

The following display appears on the screen:

	12:Ol	JAN 01	FRI
			<ON	HOOK>
LK	1	5	9	13
	mm__	____	____	-___

NOTE: The Clock/Calendar is the indication that the PC to Electra Mark11 System communications link has actually been established. Clock/Calendar may take up to one minute to appear on the display. Line status (dashed lines) will appear upon any change to line status. If you are manually dialing the on site modem using a SLT, Clock/Calendar and line status (dash lines) will appear when the modem to modem connection is made (Section 940.2.1).

Anytime ’- is Pressed on the PC, whether in idle or program mode, a SELF CHECK OK !!! display is received. This verifies that the modem and/or PC 8300 and the RAA-E Unit are communicating.

After SELF CHECK is performed, Press t (Return) before continuing with the next function. Once you are in a Memory Block, and a self check is performed, an ALARM 1 is received if another function is attempted before c (Return) is Pressed.

940.3PROGRAMMING VIA the PC-8300

Besides the LCD display of the programming Multiline Terminal, the PC also provides line button indications similar to that of the Multiline Terminal.

The display shows the letters LK (signifying Line Key) followed by four line key numbers (1, 5, 9, and 13) equally spaced.

Idle line keys are represented as dashes in groups of four under the corresponding line key numbers.

Once the modem to modem (or direct) connection is -. _! established and the RAA program is in use but not in ---

900-8