NEC nd-20292 manual Printer Connection

ND-20292

CHAPTER 7

APRIL, 1990

Figure 700-20 Locating Floppy Disk Unit PC-8231A

Figure 700-18 Inserting the AC Power Pack

Figure 700-19 Opening the PC-8231A Lid

3.Locate the PC-8300 and the floppy disk unit (PC-8231A) near each other. See Figure 700-20 Locating Floppy Disk Unit PC-8231A.

4.Connect one side of the 8-pin floppy disk cable to the FDD interface on the rear panel of the PC-8300. See Figure 700-20 Locating Floppy Disk Unit PC-8231A.

5.Connect the end with the ferrite toroid to the floppy disk unit PC-8231A. See Figure 700-20 Locating Floppy Disk Unit PC-8231A.

740.5PRINTER CONNECTION

1.Locate the PC-8300 and the printer near each other. See Figure 700-21 Locating Printer.

2.Connect the 26 pin connector (female) of the printer cable PC-8494A (or PC-82941 to the PRINTER interface on the rear panel of the PC-8300.

Figure 700-21 Locating Printer

3.Connect the 36 pin connector (male) of the printer cable to the parallel input connector of the printer.

740.6PC-8300 CONNECTION TO LCR-E ETU

1.Connect one end of the RS-232C cable PC-8495A-01 to the RS-232C interface on the rear panel of the PC-8300.

2.Connect the other end of the RS232C cable to the RS-232C connector of the LCR-E ETU which was previously mounted on the right side of the CCU in paragraph 730.8.

3.Using the APC IV (or Equivalent PC)

By ordering the IBM/LCR 5.25” or 3.5” floppy diskettes, LCR can be programmed with an NEC APC IV PC or other approved MS DOS Personnel Computer. Since the IBM./LCR floppy diskettes do not contain a disk operating system (DOS), one must be resident in the PC prior to inserting the diskettes into the PC’s floppy disk drive. LCR programming is performed by executing the file LCR, which resides on the 5.25” or 3.5” floppy diskette.

700-8