NEC nd-20292 manual Electra MARK11 System

ET1 NUMBER: MK-019

DATE: MAY, 1988

7.1.5After all parties are connected and on hoid (except the last number which was dialed), wait 5

seconds and dial 3 to establish the conference.

NOTE: After dialing 3 and establishing a conference, dialing 1 provides the initiator with

dial tone while the parties in the conference can continue their conversation.

7.2Establishing a remotely initiated conference.

NOTE: To access the CONFER@ unit from a remote location, the CONFER@ unit must be

programmed for remote access mode and an authorization code (four digit code) must already be

programmed (See step 6.1).

7.2.1Call the control line number assigned to the CONFER@ unit.

7.2.2Once the CCNFERa unit answers (after approximately 4 rings) and confirmation tone is

returned, dial the 4-digit remote access authorization code after the confirmation tone stops.

7.2.3

When dial tone

is

heard,

dial

the

telephone

number

of the first

party to be conferenced.

When

the first

party

answers,

inform

the

party

that

you

are

initiating

a conference

and then

dial 1.

(Dialing

1 puts

the

party

on

hold

and

new

dial

tone

is

received).

7.2.4Repeat step 7.2.3 until you have called all the parties to be involved in the conference

(maximum	of	five	including	the	originator).	If a	mistake	is made in dialing,	or if the number
dialed is	busy,	dial	2 to disconnect		the last	number	called.

7.2.5After all parties are connected and on hold (except the last number which was dialed), dial 3

to establish the conference.

NOTE: After dialing 3 and establishing a conference, dialing 1 provides the initiator with

dial tone while the conference continues.

7.3Terminating or leaving a conference.

7.3.1Any party that wishes to leave the conference hangs up; remaining parties continue conferencing.

7.3.2The initiator of the conference hangs up or dials # to terminate the conference.

8.PROCEDUKE

C

ELECTRA

MARK11

SYSTEM

		0
	LAST 5
	CO LINES	L
5	5	I
4	4	N
3	3	E
		5

	2	2
CONTROL LINE	1	1
		i
	CONFER	REMOTE
		ACCESS PORT

Figure 1. Typical Installation

8.1 Refer to Figure 1 for an overview of a typical installation.

3 of 5