ETI NUMBER: MK-019
5.3 initializing Repartee
5.3.1 Configure Repartee Voice Mail System
l
Enter Name of Enrolled Callers
l
Enter Extension Numbers
l
Enter Personal Identifications
. Enter Voice Names
5.3.2 Refer to the Repartee System Managers Manual for additional setup information.
5.4 Electra Mark11 System-Programming
5.4.1
5.4.2
5.4.3
5.4.4
5.4.5
5.4.6
If the VMI-E ETU(s) is being added to an existing system in an interface slot previously occupied by
a different type of ETU, it is necessary to assign the interface slot to be used for the VMI-E ETU in
Memory Block 4Cl. (Refer to Chapter 3 of the Electra Markll Installation Service Manual.) TWO
VMI-E ETUs can be installed in the system when using a CPU-EC4 ETU.
Up to four voice mail ports connected to the Repartee System can be programmed in the Voice
Mail Hunt Group in Memory Block 2C4. (Refer to Chapter 3 of the Electra Markll Installation
Service Manual.)
In Memory Block 2B8, be sure that Line Keys 1-4 are programmed as Voice Mail ports and Line Keys
9- 12 are programmed to send DTMF.
Memory Blocks 488 and 489 will remain at default values for most cases; however, be aware that
these timing parameters can be changed.
A hunt group for the VMI ports may have to be programmed in Memory Blocks 3B5 to 388
depending on the customer site requirements.
Station Speed Dial can be programmed to allow for easier access to the station users voice
mailbox to retrieve messages and/or leave messages.
3OF4