NEC nd-20292 manual ETI Number MK-017, References, Site Requirements

ETI NUMBER: MK-017

NOTE 4: in-house Fax machines may require a minimum time (number of rings) before a Fax to Fax connection can be made.

4.REFERENCES

Viking Technical Practice notes (included with product).

Viking Electronics, inc. 1531 Industrial Street Hudson, WI 54016 Sales: (715) 386-8861

5. SITE REQUIREMENTS ..

Both products must be mounted near a 120V AC source. Site location is limited only by the location of the COI- E/EB ETU port jack and the additional devices.

6.PROCEDURE

6.1For connection of the Viking Fax Jack III. See Figure 1.

6.1.1Determine the location for mounting the Viking Fax Jack III. Ensure that the desiqnated COI-E/EB ETU port iack and 120V AC power source are nearbv.

6.1.2Install the COI-E/EB ETU in an available interface slot (if an COI port is not available).

6.1.3Insert the RJl 1 connector from the Fax Jack III to an incoming CO line port jack.

6.1.4Using a modular line cord with RJl 1 connectors, connect a COI-E/EB ETU to the Phone Connector on the Fax Jack Ill.

6.1.5Using another modular line cord with RJI 1 connectors, connect the data port on the Fax Jack RI to either a fax machine, modem, or other data transmission device.

NOTE:	Switch 1 (located on the rear of the Fax Jack III) determines whether a fax machine or a modem will be
	connected to the data port.

6.1.6Plug the AC adaptor into the Fax Jack III and the 12OV AC power source. Refer to the Technical Practice notes for proper switch setting.

6.2Electra Mark II Programming

6.2.1No special programming is required for the Electra Markll. When installing the COI-E/EB ETU, a trunk number is automatically assigned for the port representing the Fax Jack III.

6.2.2Refer to the Viking Technical Practice notes for programming the Fax Jack III to your particular application.

6.2.3Test the Viking Fax Jack III for proper opration with the Electra Markll.

6.3For connection of the Viking PathFinder see Figure 2.

2OF5