NEC nd-20292 manual = Compatible, Ancillary Device, I260.2. Handsfree Unit HFU-E

ANCILLARY

DEVICES

HFU-E ETU DPA-E ETU ADA-E ETU DTA-E ETU

l = Compatible

ND-20292

				CHAPTER	2
				APRIL,	1990
Table 200-18	Ancillary Device,	dultiline Terminal	Compatibility
			I	I
ETE-6( 1	ETE-GD-( )	ETE-16-2	1 ETE-16D-(	) 1 ETE-16K-1	.
	0		8	0
	0		8	0
0	0	0	0	0
	0		0	0

C.These optional devices are installed inside the

access panel on the bottom of Multiline Terminals. A maximum of one unit of each type

can be installed in each Multiline Terminal, except for ETE-8( ) or the ETE-16-2, which can only accept the ADA-E Unit. The DTA-E Unit comes with a special access panel to allow its installation into the Multiline Terminals.

WARNING

Prior to installing any optional device, unplug the

line cord from the Multiline Terminal and the

RJlSC/W. Failure to do so could result iu damage to the optional ancillary devices.

,I260.2. HANDSFREE UNIT (HFU-E)

NOTE: For installation in all Multiline Terminals except the ETE-6-( I or the ETE-16-2.

A.Unplug the line cord at the RJ13CYW and the

terminal, then turn the Multiline Terminal upside down (face down) and locate the access panel on the bottom of the Multiline Terminal. Refer to Figure 200-41.

B.Slide the directory out of the way.

C.Insert a flat screwdriver blade into the notched opening (shown as A) and apply light upward pressure until the access panel is cleared of the front lip, at the same time apply pressure (towards you) at the rear of the pedestal (shown as B) until the access panel moves towards you.

D.Remove the access panel and place it aside for later reinstallation.

G.Secure the HFU-E Unit by inserting the screw provided with the Unit.

H.Replace the access panel

OR

continue to install the DPA-E Unit, DTA-E Unit, or ADA-E Unit.

260.3DUAL PATH ADAPTOR UNIT (DPA-E)

NOTE: For installation in all Multiline Terminals except the ETE-6-t ) or the ETE-16-2.

E.Locate the fourteen pin jack labeled HFU-E, as seen through the access view of the housing, insert the fourteen pin connector from the HFU-E Unit, as shown in Figure 200-42.

.: F. Place the HFU-E Unit into its designated area, with the cable side down.

Figure 200-41 J(u~~~a;e Terminal Access Panel

A.Unplug the line cord at the RJ13C/W and the

terminal, then turn the Multiline Terminal upside down (face down) and locate the access

200 - 35