NEC nd-20292 manual DTA-E Unit 200

ND-20292

CHAPTER 2

APRIL, 1990

Figure 200-44 Connection of DTE/DTA-E Unit

Remove the access panel, save for possible future use.

D.Before installing the DTA-E Unit, its switches should be set for the proper assignment. (Refer to Table 200-19).

The DTA-E Unit contains a 7 position DIP switch designated SW1 a slide switch designated SW2, and an 8 position DIP switch designated SW3.

Table 200-19 shows the assignments of these switches.

E.After assigning the switches, locate the fifteen pin connector labeled DTE, as seen through the access view of the Multiline Terminal housing, insert the ftiteen pin connector from the DTA-E Unit, as shown in Figure 200-45.

F.Replace the access panel.

OR

Continue to install the ADA-E Unit, DPA-E Unit,

or HFU-E Unit.

Figure 200-45 DTA-E Unit

200 - 38