NEC nd-20292 manual 700-10

ND-20292

CHAPTER 7

APRIL, 1990

C.Local Call Override

Local call override can be assigned on a system wide basis. When it is programmed, LCR does not apply to local calls on a system wide basis.

D.LCR Bypass

Should a station user find it necessary to bypass LCR, the user can directly access a CO line via a CO line button. A Single Line Telephone (SLT) or a Multiline Terminal without access to CO Line appearances can be assigned LCR bypass (on a trunk access code group basis) via Memory Block 2B9. To assign LCR bypass, line -button LB-L8 correspond to trunk access code group 2-8 respectively. Any line button LED that is lit when the ENTER key is depressed assigns the associated trunk access code group to bypass LCR.

2.System/Station Speed Dial Consideration System/Station speed dialing sometimes requires pause(s) between telephone numbers, especially when using SCCs. These pauses may cause the LCR-E ETU not to seize a least cost route, because the pauses may be considered digits dialed.

Pauses should be programmed as part of extra codes in the Extra Code Add table when system or station speed dialing is programmed to use SCCs.

The system data is programmed as follows:

,-

I

--

700-10