NEC nd-20292 manual ETI Number DT-005

ETI NUMBER: DT-005

4.2Transferring a call from handset to Speakerphone; or Speakerphone to handset.

i

4.2.1.To transfer a call from the Multiline Terminal handset to the Companion II Speakerphone, perform 1 of the two (2) following procedures.

4.2.1.1.Depress the “ON” key on the Companion II Speakerphone continuously until you hang-up.

OR

4.2.1.2.Depress the “SPKR” button on the Multiline Terminal and hang-up the handset. Then depress the “ON” key on the Companion II Speakerphone.

~_.

4.2.2To transfer a call from the Companion II Speakerphone to the Multiline Terminal handset, lift the Multiline Terminal handset.

5.PROCEDURE

5.1Turn the Multiline Terminal upside down (face down) and locate the access panel on the bottom of the Multiline Terminal, refer to Figure 1.

5.2Disconnect the modular line cord from under the telephone at the RJ-1 lC/W jack.

5.3Disconnect the modular handset cord from the lower housing.

5.4Slide the directory out of the way (Not required for ETE-6-O or ETE-16-O Multiline Terminal).

5.5To remove the access panel, perform only the step that applies, either 5.5.1 or 5.5.2 (Refer to Figure 1).

5.5.1ETE-6D-0, ETE-160-0, or ETE-16K-1 Multiline Terminal; Insert a flat screwdriver blade into notched opening (shown as A) and apply light upward pressure until the access panel clears the front lip, at the same time apply pressure (toward you) at the rear of the pedestal (shown as 6) until the access panel moves toward you. Remove panel.

5.5.2ETE-6-0, or ETE-16-O Multiline Terminal; Depress the flexible notched tab (shown as C) on the access panel and apply upward pressure. Remove panel.

NOTE 2

Do not discard removed access panel; save forpossible future use.

5.6Locate the four pin connector and jack labeled HAND (as seen through the access view of the

Multiline Terminal housing). Unplug this connector and extend it out from the housing access opening.

5.7Set the SW2 DIP switches, on the ADA-E unit, as shown in Table 1 of Figure 2. Place the jumper across pin ST2 and the center pin. Set SW1 to the MAKE position.

5.8Remove about l/4 inch of inner insulation from both ends of the two conductor wire.

2of7