NEC nd-20292 manual Ryl

7.Select the RAA Unit Switch 5 (A,B) setting. If the System Data Up/Down Load software is being used, the Switch 5 setting in the RAA must be set for low. In addition, you must be using COMLINK V2.0 or higher. Refer to Section 920.1 number 5.

For example: Type B Display shows:

RAA TERMINAL EMULATOR

A) Corn 1 B) Corn2

RAA Unit Switch 5 Selection

A) High (Refer to I/S Ch. 9)

B) Low

Select Baud Rate

A: 2400 Baud B: 1200 Baud

C: 600Baud D: 300Baud

- -1

8.Select baud rate (A, B, C, or D). Ensure the baud rate selected matches the baud rate of the modems and that of the RAA-E Unit

Display shows: (If modem is used.) Otherwise see display in step 10 and continue from there.

ND-20292

CHAPTER9

APRIL.1990

(If left in this mode, the time and date will appear in the screen. Example 11:58)

isumes modem is connected to DTMF Telco line

ryl :\>_

10.Enter AT0 and Press t(RETURN). Computer screen returns to the RAA display. (Pressing the ESC key at any time during programming brings up the modem screen; pressing ALT H any time during programming brings up the help screen).

NOTE: With RAA Unit Disk V2.0 or higher, the screen will show “RAA Check” after AT0 has been entered. Programming can begin when this message disappears. If an error is displayed, refer to SW5 setting in Section 920.1

<MARKII>

11:58 JAN 01 SUN

c ONHOOK >

9.Enter ATD’I’* followed by the telephone number for the modem associated with the RAA-E at the

job site and press c(RETURN) (EX: ATDT 7530093 *(RETURN) 1

a)Modem will go off line and will dial the telephone number entered.

Display shows:

I,,,“““““.‘.

I : \ > ATDT 753 0093	I
I	I

b)Carrier tone is received and a connection is made.

	LK	1	5	9	13
	Alt H =	Heln		Esc = Modem Online
I	:\>
	AT0

11.Press @ to go off-hook. Display shows:

	< MARK11 >
	EXT LINE		< OFFHOOK >
11:59 JAN 01 MON
LK	1	5	9	q
	____	____	____ ___
			l3
Alt H = Help		Esc = Modem Online
:\	>

900 - 13