NEC nd-20292 manual Remote Administration Adaptor

ND-20292

APRIL, 1990

CHAPTER 9

REMOTE ADMINISTRATION ADAPTOR

TABLE OF CONTENTS

SECTION DESCRIPTION PAGE

910 EQUIPMENT DESCRIPTION

910.1Remote Administration Adaptor

	Unit(With Host Disk)	900-l
910.2	PC-8300 Personal Computer	900-l
910.3	PC-8231A Micro Floppy
	Disk Drive	900-2

910.4PC-8295A-01 RS232C

Cable - Normal900-2

910.5PC -8295A-02 RS232C

Cable - Reversed900-2

910.6 Modems 900-2

920RAA-E and MODEM INSTALLATION

950.3	PC System Setup	900-15
950.4	Creating a Directory	900-16
950.5	Remote Operation Setup	900-16
950.6	Operating Procedures	900-16

SECTION 910

EQUIPMENT DESCRIPTION

910.1REMOTE ADMINISTRATION

ADAPTOR UNIT

The Remote Administration Adaptor Unit @AA-E) is a compact, self contained unit (7.9 in x 3.9 in x 1.9 in, 200mm x 1OOmmx 50mm) that allows remote or local programming of the Electra Mark11 system by means of a personal computer.

920.1 RAA-E Unit Switch Settings 900-3

920.2Wall Mounting the RAA-E Unit 900-4

920.3Connecting the RAA-E to the

Electra Mark11 900-5

920.4Connecting the RAA-E to the

Modem900-5

920.5Connecting the Modem to a Line 900-5

920.6Grounding the RAA-E and Modem 900-6

920.7 Modem to Modem Connection 900-6

930PC-8300 and PC-8231A

INSTALLATION

(Refer to Sections 740 and 750.5)

940PROGRAMMING

940.1	General	900-7
940.2	Program Boot Procedure	900-7
940.3	Programming via the PC-8300	900-8
940.4	Programming Example	900-9

940.5IBM Type Compatible Version

Software900-12

940.6General Programming Notes 900-14

950SYSTEM UP/DOWN LOAD

950.1 General 900-15

950.2Equipment Required and

Installation900-15

The RAA-E Unit contains an RJllC modular jack for connection to the Electra Mark11 system, and an RS232C connector for connection to a modem or a PC. It also contains 5 switches for proper interface settings; a green LED to indicate power is available; a hybrid IC card for interfacing with the system; an 8-bit processor; a 16KBYTE ROM IC; and associated circuitry.

The RAA-E Unit requires no external power source. It is powered by the Electra Mark11 system via the modular jack connection.

The function of the RAA-E Unit is to translate the Manchester Encoded data (from the ESI-E( ) ETU) to ASCII signals for use by the PC or modems.

A floppy disk is supplied with the RAA-E Unit. This disk software is written in one of two formats:

A.CP/M-DOSN 82 Basic (for use with the NEC PC-8300 or equivalent computer).

OR

B.MS-DOS@ Basic (for use with the NEC APC IV or equivalent computer).

The CPM-DOS is available in one disk size, 3.5 inches. The MS-DOS@ is available in one of two disk sizes, 5.25 inches or 3.5 inches.

900 - 1