NEC nd-20292 manual Memory Block 4B8 VMI Initialize 1 Assignment, Mode Initial, SLOT? VMI Initial

ND-20292

CHAPTER 3

APRIL, 1990

MEMORY BLOCK 4B8 - VMI INITIALIZE 1 ASSIGNMENT

j-> 1’

OPERATION f--------D-

1.Co off line.

2.Depress F4, then F7.

3.Depress F18.

4.Dial the module number to be assigned. Example: Module 1.

5.Dial the slot number to be assigned. Example: Slot 7.

6.Dial the channel number to be assigned. Example: Channel l.(See Note 1).

			DISPLAY
OF		F	- LINE		(X-XX)
PROGRAM				MODE
CARD			MODE
.V M	I		INITIAL		lZE1
MOD?			SLOT*		CH*
VMl			INITIAL		IZEl
<MOD		1	SLOT?		CH*
VMI			INITIAL		lZE1
MOD		1	SLOT7		C H	?
VM	I		INITIAL		IZEl
MOD		1	SLOT	7	C H	1

NOTE: The following conditions apply when either the first or second VMI-E ETU is entered.

Channel 1 affects VMI-E Ports land5

Channel 2 affects VMI-E Ports 2and6

Channel 3 affects VMI-E Ports 3and7

Channel 4 affects VMI-E Ports 4and8

(CPU-EC4 or higher revision is required to support two VMI-E ETUs)

7.Depress Ll to L12 to set the desired timing parameters of the selected VMI port. (See Note 2).

8. Depress ENTER key. (See Note 4).	VMI		INITIAL	IZEl
	MOD	1	S L OT 7	C H 2

9.Repeat steps 7 and 8 for all VMI ports to be assigned.

10.Depress the SPKR key to go back on line.

300-210