NEC nd-20292 manual Connection of a Panasonic Autodialer, ETI Number DS-007 Date April Description

CONNECTION OF A PANASONIC AUTODIALER

TO A Dterm II (ETE-1-2)

Dterm II

ETI NUMBER: DS-007 DATE: APRIL, 1990

DESCRIPTION

This Engineering Technical information (ETI) Bulletin provides installation instructions for connecting a Panasonic Autodialer to a Dterm II telephone (ETE-l-2).

2.LIMITATIONS

2.1Autodialer should be turned off after the call is established.

3.PARTS REQUIRED

3.1Dterm II (ETE-l-2).

3.2Panasonic Autodialer (model KX-T1235D)

Autodialer is available at any local Panasonic sales office.

3.3RJ-35X Modular jack

3.4Needlenose pliers.

3.5Four pieces of 24 AWG wire (minimum length: 6” each)

3.6Four small spade lugs.

REFERENCES

4.1Panasonic Autodialer installation Guide.

4.2Dterm II (ETE-l-2) Users Guide.

OPERATION

5.1Depress the ON/OFF button on the Autodialer to the ON position.

5.2If using the Speed Dial button, set the Dialing Selector to Auto mode on the autodialer. If using the dial pad on the Autodialer, switch the Dialing Selector to manual mode.

5.3Depress the desired Speed dial button or use the dial pad to place a call.

5.4Monitor the call through the speaker of the Autodialer.

5.5When the called party answers, lift the handset, depress the ON/OFF button on the Autodialer to OFF and converse.

6.PROCEDURE

6.1Disconnect the line and handset cord from the Dterm telephone.

6.2Place the Dterm II upside down on a clean, flat work surface.

6.3Slide the Directory out and place it aside.

1 OF5