NEC nd-20292 manual Programming the LCR-E ETU KEY Layout and Explanation of Keys

ND-20292

CHAPTER 7

APRIL, 1990

NORMAL END

NORMAL END 4

2.In MODIFY mode, when first accessing a ROUTE TABLE, if you enter ‘00x’ for a table #, the program aborts back to DOS. If‘x‘ is entered first, the problem goes away.

3.In MODIFY mode, ifX is used to clear an entry in a ROUTE TABLE, every line in the display gets

shifted up. :*

4.INSERT and DELETE functions do not work.

5.System Control: after ‘PHASE EXECUTING’ is over:

INORMAL END I

is written over ‘PHASE EXECUTING’.

Field display should read:

PHASE EXECUTING

NORMAL END J

IABNORMAL END

LINE TROUBLE

is written over ‘PHASE EXECUTING’. Field display should read:

PHASE EXECUTING

ABNORMAL END

LINE TROUBLE el

PC 8300 LCR

1.If C is used (by mistake when trying to input Xl, LCR program aborts back to BASIC.

750.7PROGRAMMING THE LCR-E ETU

KEY LAYOUT AND EXPLANATION OF KEYS

General Information

Once the initialization procedure has been completed, powering up the PC-8300 results in a display of the LCR main menu. (See section 740.5 for the initialization procedure if this has not been completed.)

Figure 700-28 Keyboard Layout and 700-29 General Programming Flow Diagram show the keyboard layouts and the keys which are used during programming of the LCR-E ETU, when using a PC- 8300 and an NEC APC IV, respectively.

700 - 20