Toshiba Release 4.0 manual Placing phone calls through the remote Server

Immediately connecting to dial tone on the remote Server

You can configure the dialing service to allow users to actually hear the remote Server’s dial tone, so they can log in and check remote voice mail boxes, or press 411 to access the dial-by-name directory on the remote Server.

1.Create a dialing service exactly like the one described above.

2.Set Minimum and Maximum number of digits to 0.

With these settings, Strata CS connects to the remote dial tone immediately after the access code is entered (for example, 71), rather than waiting for digits to be collected by the local Server and then passed to the remote Server.

Note: Another way of accomplishing the same thing—without changing the minimum and maximum digits—is to instruct users to press # immediately after dialing the access code, as in 75#.

Placing phone calls through the remote Server

To place outbound calls through a remote Server over IP, you must create an

Internet-to-Phone Number dialing service.

1.Choose File > New > Dialing Service > Internet-to-Phone Number

Service.

2.On the General tab, enter the following information about the remote Strata CS Server:

n IP Gateway. Select the IP Gateway that will direct calls from this dialing service to a remote Strata CS Server. See “Creating an IP

CHAPTER 13. CONFIGURING INTERNET TELEPHONY SUPPORT 13-15

BETA DOCUMENT - PRELIMINARY & CONFIDENTIAL