Cisco Systems 78-17630-01 appendix Line Tab, 115

Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards

Optical Cards

D.4.5.3 Line Tab

The Line tab allows you to view and update OC3 IR 4/STM1 SH 1310 optical line performance monitoring information.

Table D-121 Field Descriptions for the Line Tab

Field	Description
Line Config
Port Number	Displays the optical port number.
Port Name	Allows you to enter the name of the optical port.
SD BER	Sets the signal degrade bit error rate.
SF BER	Sets the signal fail bit error rate.
Type	Defines the port as SONET or SDH.
PJSTSMon#	Sets the STS that will be used for pointer justification. If set to 0, no STS is monitored. Only one STS
	can be monitored on each OC-N port.
	• 0 (Cisco default)–3 (OC3, per port)
	• 0 (Cisco default)–12 (OC-12)
	• 0 (Cisco default)–48 (OC-48)
ProvidesSync	If checked, the card is provisioned as an NE timing reference.
EnableSyncMsg	Enables synchronization status messages (S1 byte), which allow the node to choose the best timing
	source.
Send DoNotUse	When checked, sends a do not use (DUS) message on the S1 byte.
Admin State	Displays the status of the line. The line can be In Service (IS), In Service–Auto In Service Soak
	(IS_AINS), Out of Service (OOS), or Out of Service–Maintenance (OOS_MT).
AINS Soak	Automatic in-service soak. The determination of duration left before the traffic/termination
	transitions to IS state.
AINS Soak Count	Automatic in-service soak countdown. Displays the remaining time of valid input signal in hh:mm,
Down	after which the card becomes in service (IS) automatically.

	Cisco Transport Manager Release 7.2 User Guide
78-17630-01		D-115