Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
D.4.13.4 VC-4 Config Tab
| | The VC-4 Config tab allows you to view and update S16.1-1-LC information. |
Table D-173 | Field Descriptions for the VC-4 Config Tab |
| | |
Field | | Description |
| | |
VC Number | | Displays the VC number. |
| | |
IPPM Enabled | | Check to enable intermediate path performance monitoring (IPPM) and uncheck to disable IPPM. |
| | |
XC Loopback | | Indicates cross-connect loopback. |
| | |
D.4.13.5 Loopback Tab
The Loopback tab allows you to view and update S16.1-1-LC loopback information.
Table D-174 Field Descriptions for the Loopback Tab
Field | Description |
| |
Port Number | Displays the port number. |
| |
State | Displays the current loopback state. |
| |
Loopback Type | Allows you to configure a port to terminal loopback (Inward) or Facility (Line), or clear the current |
| loopback (None). |
| Note The line state must be OOS_MT before you can configure the loopback type. |
| |
Note See Table 1-20 on page 1-44for descriptions of actions that can be performed using the buttons at the bottom of the window.
D.4.14 Slot Properties—STM-1
The Slot Properties pane displays information about the Cisco ONS 15454 SDH slot that is selected in the NE Explorer tree. Use this properties pane to change the module performance monitoring thresholds.
The STM-1 IR 4/STM1 SH 1310 (STM1_4 and STM1_8) card provides four or eight intermediate or short range, ITU-T G.707-, ITU-T G.957-compliant, SDH STM-1 ports. Each port operates at
155.52Mbps over a single-mode fiber span. The card supports concatenated or nonconcatenated payloads at the STM-1 signal level on a per-VC-4 basis.
For the STM-1 module, the Slot Properties pane displays the following tabs: Module View, Identification, Line, VC-4, Loopback, Protection, Alarm Behavior, Auto Laser Shutdown, and J1 Path Trace. The tabs shown depend on the NE configuration.
D.4.14.1 Module View Tab
The Module View tab displays a graphic of the STM-1 that is installed in the slot. The number of critical, major, minor, and warning alarms for the module is displayed under Alarm Status. (Alarms are also displayed when you move the mouse pointer over the graphic.) The Suppress Alarms check box is read-only and indicates whether all alarms are suppressed for the card and its port(s).
| Cisco Transport Manager Release 7.2 User Guide |
D-162 | 78-17630-01 |
