Appendix D Slot Property Information—FC_MR-4, FMEC, Multirate, Optical, and Transponder Cards
Optical Cards
D.4.12.4 WAN Line Tab
| The WAN Line tab allows you to view and configure wide-area network (WAN) line information. |
Table D-170 | Field Descriptions for the WAN Line Tab |
| | |
Field | | Description |
| | |
Port Number | | Displays the optical port number. |
| | |
Port Name | | Allows you to enter an optical port name. |
| | |
Link State | | Displays the physical port state. Possible values are Up, Down, or Not Present. |
| | |
Note See Table 1-20 on page 1-44for descriptions of actions that can be performed using the buttons at the bottom of the window.
D.4.13 Slot Properties—S16.1-1-LC (ONS 15305 CTC)
The S16.1-1-LC module contains one optical STM-16 interfaces that meets the S-16.1 specification in ITU-T G.957. The physical connector is an LC connector. The module only supports TDM traffic.
The Slot Properties pane displays information about the Cisco ONS 15305 CTC slot that is selected in the NE Explorer tree. Use this properties pane to change the module performance monitoring thresholds. A module diagram is shown in the following figure.
Figure D-4 Single Optical S-16.1 Module, S16.1-1-LC
For the S16.1-1-LC module, the Slot Properties pane displays the following tabs: Module View, Identification, STM Line, VC-4 Config, and Loopback.
D.4.13.1 Module View Tab
The Module View tab displays a graphic of the S16.1-1-LC that is installed in the slot. The number of critical, major, minor, and warning alarms for the module is displayed under Alarm Status. (Alarms are also displayed when you move the mouse pointer over the graphic.) The Suppress Alarms check box is read-only and indicates whether all alarms are suppressed for the card and its port(s). Right-clicking the graphic opens a shortcut menu that you can use to reset, delete, or change the card.
| Cisco Transport Manager Release 7.2 User Guide |
D-160 | 78-17630-01 |
